Der LBD2 ist ein Gitarrenpedal mit gleichem Tondesign wie sein Vorgänger, dem LBD. Je nach Verstärkungseinstellung bietet der LBD2 einen knackigen und vollen Klang mit vielen Mitten. Um den besten Sound zu erzielen, empfiehlt es sich, den Tone-Regler zu nutzen, um die hohen Frequenzen abzusenken, sowie den Lautstärke- und Mid-Schalter an der Oberseite des Pedals einzustellen. Der Mid-Schalter ermöglicht eine kontrollierte Einstellung des mittleren Frequenzbereichs. Das Pedal kann mit einer 9V-Batterie oder einem externen Netzteil betrieben werden, verfügt aber auch über einen eingebauten 16V-Wandler. Die Verwendung eines 16V-Netzteils bietet mehr Headroom, einen größeren Dynamikbereich und reduziert die Kompression. Es wird empfohlen, bei Verwendung eines externen Netzteils mit 16V den erhöhten Stromverbrauch des Pedals zu berücksichtigen. Beim Öffnen des Pedals sollte der Schiebeschalter auf der Platine überprüft werden, um die Steuerspannung auf 9V oder 16V einzustellen.

LBD2 has the same tone design as the previous LBD. In low gain, it's crunchy and full of mid-range. In high gain, it's crisper and more focused. To get the best sound, use a tone control to cut high frequencies, a volume control, and the mid switch (for mid-range strength) at the top of the pedal. The mid switch controls the mid-range. It's a tone setting that pushes the midrange in three stages from the foot switch to the DC jack. Check the slide switch on the board when you remove the back panel. This slide switch sets the effect drive voltage to 9V or 16V. The LBD2 can be used with a 9V battery and an external power supply, but it also has a built-in 16V converter. A 16V drive gives more headroom and a wider dynamic range. It also reduces compression. Use an external power supply with 16V as the current consumption of the power supply increases.

Demo by Simon Gotthelf Gear Demos (Simon Gotthelf Music)

Demo by Shawn Tubbs

Product Page

Review by delicious audio

Review by The Gear Page

Review by bonedo

Manual

Little Brute Drive II (LBD2)

The new Bass Mid Control is the active mid-controller for bass players. A small but powerful pedal that provides frequency control adjustments between 120Hz ~ 3kHz. When using 2-band EQ or passive bass, the Frequency control provides excellent manipulation of the mid frequencies, while the Boost/Cut gives you boosting or cutting capabilities of up to + / - 12dB. This compact pedal can also be powered by a 9V battery or for additional headroom use an 18V power adapter. This pedal will provide you the flexibility to play any musical style.

Demo by Hablandoen Grave 

Stormy Bass Drive is the first Bass overdrive pedal by E.W.S. A wide range of gain settings is possible, covering from clean boost sounds to fat crunch sounds, even deep high gain sounds. The toggle switch installed on the top of the pedal can set 3 types of EQ modes: Mid Boost, Normal, and Mid Cut. Mid Boost boosts 6dB around 750Hz and Mid Cut cuts 6dB around 400Hz. A tube-like and touch-sensitive drive sound can be obtained by always mixing two gain stages with different frequency characteristics, in addition to an amplification circuit that combines a MOS FET and a low-noise operational amplifier. Though being an ultra-compact pedal, a 9VDC external power supply or built-in 006P battery drive is possible, in addition to 3 controls (volume, tone, gain) and 1 mode switch (mid EQ) on the top of the pedal. A DC-DC converter is built in the power circuit, and the input 9VDC is converted to 16VDC. By using a 16VDC drive, a fat, cored low range and a firm high range are realized even when high gain is set.

Review by Basschat

Review by Talk Bass.com

Demo by 【ムツミ】Mutsumi

Demo by The Bass Channel

Stormy Bass Drive

Following the very well received Brute Drive, we are proud to introduce the newest pedal from EWS, the Little Brute Drive (LBD). From its small body, jumps out an intense distortion similar to its big brother, the Brute Drive.

Its compact design takes us very little real estate. It will fit anywhere you desire on your pedal board. But don't let the small size fool you. This simple one-knob powerhouse produces heavy crunch to fiery distortion sounds. Output level and treble control can be adjusted with 2 trimmers located on the PC board inside the pedal.

This is an overdrive/distortion pedal that is compact in size, user-friendly and surely to become your work-ready weapon! And of course, it's true-bypass.

Review by Guitar Gear

Demo by Michael Thompson

Demo by Steve Stevens

Little Brute Drive (LBD)

Our small mid controller for Bass, BMC has been renewed! The BMC2 has an added gain boost switch that provides +10db of gain increase at the input stage. With the added volume control, unity gain can be achieved or with the gain boost engaged, you can add up to +6db of volume. In addition to the previous midrange boost and cut, it can now be used as a clean booster or as a preamp with a wide range of tone control. Furthermore, it is possible to generate 18VDC by a built-in DC-DC converter in BMC2.
It is a able to select 9VDC or 18VDC by an internal Dip Switch.

Featured Artists

BMC 2

Media

Videos

Handbücher

Links

Technische Daten

Weitere Pedals von E.W.S

E.W.S

Little Brute Drive II (LBD2)

E.W.S

BMC

E.W.S

Stormy Bass Drive

E.W.S

Little Brute Drive (LBD)

Produkte

Bau dein Board

Services

Community