Teeth MKII

PREAMP
OVERDRIVE

Description

Teeth was a necessary evolution. 'Straight into amp' clean was always dull, especially at volumes correct for small stages, or late night recordings. Overdrives added too much crunch, even at the lowest settings. Teeth is the solution to the conundrum. It is a low gain pre-amp / overdrive with a blend between completely clean and slight grit. Use it as an 'always on' to brighten up old pickups or kick some colour into your signal chain or as a standalone overdrive - up to you. New for the Teeth MKII, the Breath knob gives you continuous control of the high frequencies. In the centre of the pot, the high frequencies are flat, and either way you can cut or boost to add colour. The Teeth MKII also runs from 9-18V DC power, so you can choose the amount of headroom that the pedal runs at. The original Teeth had an internal charge pump, running the pedal at around 17V from a 9V inp

Media

Videos

Demo by Brock Davisson (EN)

Demo by Sasha Ivantic (EN)

Technical data

Width
3.74 in
Depth
4.96 in
Height
2.01 in
Weight
0.92 lbs
Circuit type
analog
Voltage
9V DC, center negative
Current
42mA